TI811X PSP 04.07.00.01 rc1 Release Notes

This page is currently under construction. The content of this page is due to change quite frequently and thus the quality and accuracy are not guaranteed until this message has been removed. Please feel free to contribute to this page while construction is in progress.

TI811X PSP 04.07.00.01_rc1 Release Notes

Linux PSP

Important
This document covers details for TI811x 04.07.00.01 release candidate 1 tag available on Arago. This is not part of any formal release (yet) and has gone limited testing on TI811x EVM (Base board).

Release Notes

04.07.00.01 Release Candidate 1: June 01, 2012

Document License

This work is licensed under the Creative Commons Attribution-Share Alike 3.0 United States License. To view a copy of this license, visit http://creativecommons.org/licenses/by-sa/3.0/us/ or send a letter to Creative Commons, 171 Second Street, Suite 300, San Francisco, California, 94105, USA.

Read This First

TI81xx

Video Related

• Make sure that PIN8 of SW6 switch is turned on(to make off-chip HDMI display and EVm LCD display work).
• Off-Chip HDMI is working with only small lilliput display, samsung and philips TV.

TI811x

Hardware modification for 16-bit NAND

16-bit NAND is supplied with the EVM but the bus width selection switch is not populated on the EVM. By default, GPMC_D[12] is pulled down, hence corresponding to 8-bit NAND support. So, to support the NAND boot on the EVM (having 16-bit NAND), the following modification has to be done:

• Pull up GPMC_D[12]: the resistor populated at R336 should be moved to R313
  

This will set BTMODE12 to 1, which is the required configuration to support 16-bit NAND.

USB Overcurrent on USB1 port:
Please use daughter board for USB1 support, refer to TI811X known issue section here

Ethernet Switch setting
For Connecting EMAC1 Phy

• SW7.1 - On

GPMC and EMAC Pin Mux Selection

SW10.2	GPMC/EMAC Pinout connects to
ON	GPMC
OFF	EMAC

• GP5[4] is by default low and not programmed

The code base for Linux kernel and U-Boot included in this release is hosted at the following repositories:

Component	Repository (Branch)	Baseline Tag/Commit	Release Tag
TI81xx Linux Kernel	http://arago-project.org/git/projects/?p=linux-omap3.git;a=shortlog;h=refs/heads/ti81xx-master (ti81xx-master)	2b3ea6aa16956e15f1ba8e7b70898aaacbec2237	v2.6.37_TI811XPSP_ENG4_REL
TI81xx U-Boot	http://arago-project.org/git/projects/?p=u-boot-omap3.git;a=summary (ti81xx-master)	v2010.06	v2010.06_TI811XPSP_ENG4_REL

The kernel and U-Boot have been compiled with CodeSourcery GNU Toolchain for ARM Processors 2009-q1-203 based on GCC 4.3.3

Dependencies

For complete list of components versions that will work with this release, please refer to the Software BOM page at http://processors.wiki.ti.com/index.php/Category:EZSDK_Software_BOM

This release requires following tools/packages to be installed for fbdev/v4l2 drivers:

Tool/Component	Release Version
CCS	5.0.3.00013
CGTools	4.9.2
XDC	3_23_01_37
BIOS	6_33_02_27_eng
IPC	1_24_01_24
Syslink	2_10_02_17
HDVPSS Binary	01.00.01.37

What's Supported

The Linux PSP package supports the following components:

U-Boot Features

	TI811X
NAND	YES
NOR	NO
SPI	YES
SD	YES
Ethernet	NO
Pre-built binaries for U-Boot (for SD and NAND boot mode only), Linux kernel	NO
Pre-Built binaries for NAND, NOR and SPI flash writers	NO

Linux Device Drivers

	TI811X	Remarks
DCAN	YES
NAND	YES
UART	YES
I2C	YES
SATA	YES
NOR	NO
EDMA	YES
SPI	NO
V4L2 Capture	NO	TI811X platform has only TVP5158 decoder, and it is multichannel. V4L2 framework does not support multichannel capture.
V4L2 Display	YES
SII9022a external HDMI transmitter driver	YES
HDMI Audio	NA
AIC3106 Audio	YES
ADC3101 Audio	NA
Ethernet Switch	YES
PCIe RC	NO
PCIe EP Boot	NO
PCIe EP Driver	NO
MMC/SD	YES
Watchdog Timer	YES
GPIO	YES
AVS	NO
Pinmux	YES
USB Host	YES	HID/MSC/Audio/Video
USB Gadget	YES	CDC/RNDS/FSG
RTC	NO
CIR	NO

New in this Release

Following features have been added in this release

Fixed in this Release

This section lists issues fixed in this release:

TI81XX

Issue Identifier	Issue Headline
SDOCM00089892	TI81XX: USB: video capture and play from usb camera (Logitech pro 9000) fails for 640X480 resolution
SDOCM00090443	TI814X: USB: HP DVD-RW drive connected to DM814x causes kernel crashes
SDOCM00088387	Centaurus: USB audio through aplay does not work intermittently when stopped (by control-c) and started again
SDOCM00090821	DM814X: USB: video capture using usb logitech pro 9000 camera does not work for 1600x1200 resolution
SDOCM00090854	DM81XX: USB: musb driver shall use the non-posted read/write API for all register access.

Known Issues

This section lists known issues observed in this release:

TI81xx

Issue Identifier	Issue Headline	Known Workaround(s)
SDOCM00081588	TI81XX:USB: After four times insmod and rmmod of ti81xx.ko in loop causes crash in dma_alloc_free in cppi41dma driver	Remove all the modules in reverse order and insert all modules in right order again.
SDOCM00087448	TI81XX: USB_Audio : DUT hangs for 8 to 10 sec while unpluging the USB audiodevice during playback	The issue is with aplay application does not exit after device disconnect. Recommeded to stop the audio playback before unplugging of audio device.
SDOCM00088375	TI81XX: USB: (short packet issue) multiple resets occuring while creating a file on HP flash disk.	Known Issue, SW workaround patch available, but not complete solution.
SDOCM00091461	USB: CPPI41DMA: TX DMA generates the early completion interrupt before last byte from endpoint TxFifo is transferred out.	Known Issue, SW workaround patch available.
SDOCM0086738	Extra IN token issue: While file transfer thru usbwifi client dongle to tftp server & do i/o on HDD, intermittent usbreset occurs	Known Issue, SW workaround available. Configuring the rx transfer in transparent DMA mode and handling the data toggle appropriately.
SDOCM0091179	DM814X: USB: MUSB interrupt during DMA transfer without appropriate cause of interrupt	Known Issue, no workaround
SDOCM00086741	DM81XX: USB: While performing USBCV test with Remote wakeup capability(rndis) the EVM console freezes till test is completed.	None
SDOCM00084561	USB:TI81XX: Dynamic detection of USB-ID pin not working when device connected after linux bootup	Configure USBx_ID pin appropriately for host/device role. USBx_ID pin to Short (for host mode) and open (for device mode).
SDOCM00086735	TI81XX: USBOTG: The SRP (Session Request Protocol) initiated from OTG-B peripheral device is not working	None.
SDOCM00085989	TI81xx:V4L2 Capture: FPS is low with capture +fbdev loop back	None
SDOCM00085993	TI81xx:V4L2 Capture: Kernel dump is seen on starting capture	None
SDOCM00086261	TI81xx:V4L2 Capture: Filter is always selected for 1080P60 mode	None
SDOCM00087388	TI81xx:V4L2 Capture: I2CAdapter on which slave is connected should be a platform device field.	Change V4L2 driver code to hardcode the adapter to which slave is connected
SDOCM00082602	SD removal while IO is in progress causes system hang	None. It is recommended not to remove the card while I/O is in progress.
SDOCM00089115	Subpage support in NAND is not implemented	None

TI811X

Issue Identifier	Issue Headline	Known Workaround(s)
SDOCM00090415	TI811X: There is continuous overcurrent message on console from USB1 port when kernel loaded in usb host mode on TI811X EVM	Known issue: Always connect the daughter board to use USB1 port other wise to disable the USB1 port use steps in this patch. Note that this patch will not apply directly, edit the specific changes manually as mentioned in the patch.
SDOCM00090994	TI811X audio playback lag due to incorrect input clock frequency on TI811X EVM.	Workaround is modify the codec clk value to 20MHz from 22.5792MHz in sound/soc/davinci/davinci-evm.c. Patch file downloadFile:J5_audio_clock_src_bug_fix.zip
SDOCM00092768	U-Boot trace Showing device as "TI811X-GP rev 1.0", it must be "TI811X-GP rev 1.1.	Workaround patch download File:0001-TI811X-fixed-the-PG-version-print-on-ti811x.zip

Installation and Usage

Please look for detailed installation and usage instructions in the User Guide

Upgrade and Compatibility Information

To upgrade to new PSP release, simply delete the old release and extract the new release in its place.

Device Support

This release supports following setups

• TI811x VM

Validation Information

This release is tested on

TI811x Base EVM with ARM running @600MHz and DDR @400MHz

Versioning

This is 04.07.00.01_rc1 release of TI81XX Linux PSP product.

Useful Links

PSP 04.04.00.02 User Guide

PSP 04.04.00.02 Feature and Performance Guide

PSP 04.04.00.02 Release Download Page

Technical Support and Product Updates

For further information or to report any problems, contact http://community.ti.com or http://support.ti.com.

OMAP Linux Mailing List: http://vger.kernel.org/vger-lists.html#linux-omap </div>