NOTICE: The Processors Wiki will End-of-Life on January 15, 2021. It is recommended to download any files or other content you may need that are hosted on processors.wiki.ti.com. The site is now set to read only.
- This page was last edited on 3 June 2011, at 10:16.
- Content is available under Creative Commons Attribution-ShareAlike unless otherwise noted.
I am new to this forum. I need to get help with Serial Boot and Flash Loading Utility for OMAP-L138. I have rebuilt the code for my board, and it seems to communicate successfully, but when I try a command such as:
sfh_omap-L138 -p COM4 -flashType NAND -erase
to test erasing the flash, the communication works OK, but the target board does not erase the flash. There is no error message; the host thinks it was successful.
Any thoughts on how to debug this?
For that matter, did I even post this in the right place? If not, can someone tell me where I should have posted this question?
Thanks!
Mike
--Earthmichael 11:16, 3 June 2011 (CDT)